Table of Contents
Advertisement
Chapter 10 SmartID Testing
About the SmartIDs
About the SmartIDs
The SmartIDs
SmartID device which then communicates with any other connected SmartID devices in order to
certify an in-home network and provide distances to found impairments. See
Figure 16 SmartID
The difference in the SmartIDs versus the other terminators is that the terminators only indicate their
location, whereas the SmartIDs each also are used to identify their location, but also each SmartID
does a broadband noise ingress measurement, dual-ended FDR for coax mapping and frequency
sweeping to locate impairments.
Figure 17 SmartID connection
If a Diplexer is on the network, disconnect the VDSL connection.
There are three test modes
78
(Figure
16) allow a technician to connect the <product name> directly to any single
SmartClass TPS User's Guide
22035456, Rev 001
Figure
17.
June 2014
Advertisement
Table of Contents
Troubleshooting
