Specifying Test Settings - JDS Uniphase SmartClass User Manual

Specifying test settings

Before you begin testing, make sure the test settings on the SmartClass Triple Play Services match
the settings of the line and network configuration you are testing.
TIP:
Test configurations can be stored for easy recall and use (see
page
To specify test settings
1 From the IP Video menu, select Video Setup, and then specify the settings.
Configuring the settings can be done one of two ways:
– Press a number on the key pad that corresponds to the setting you want to configure.
– Use the arrow keys to highlight the setting you want to change, and then press the OK key.
Press the Cancel key to exit a menu.
NOTE:
You must specify the interface settings before specifying Video settings. For example, you must
configure the Data, LAN, and other applicable settings for a xDSL line.
The following table describes the settings.
Setting
Mode
Analysis Type
IGMP Version
RTSP Port
RTSP Vendor
2 To specify settings for a particular stream, do the following:
a
These settings are only available in Terminate Mode.
b
June 2014
29).
Description
Select Terminate or Monitor mode.
Select Normal or UT Starcom.
Use UT Starcom when analyzing Rolling Stream video streams.
If you are in Terminate mode, specify the version of IGMP signaling being
used on the circuit: version 2 or version 3.
Enter the RTSP port number.
This is the port where RTSP signaling communication takes place in a partic-
ular network.
Enter the RTSP vendor.
This setting is only relevant in Terminate mode.
From the Video Setup menu, select the Stream Setup for the desired stream, for example
Stream 1 Setup.
Specify the settings.
SmartClass TPS User's Guide
22035456, Rev 001
Chapter 12 IP Video Testing
Specifying test settings
"Managing test configurations" on
95