Exploring The Connector Panel; Dsl Connector; Pots Connector; Usb Host Connector - JDS Uniphase SmartClass User Manual

Exploring the connector panel

The SmartClass Triple Play Services connector panel is used to connect to the line under test.
Figure 2
Figure 2 SmartClass Triple Play Services connector panel
The connector panel varies slightly depending on the configuration. The following paragraphs
describe each of the connectors on the right-side connector panel.

DSL connector

Use the 8-pin modular DSL jack when connecting to DSL circuits.
CAUTION: FIRE HAZARD
To reduce the risk of fire, use only 26 AWG / 0.6mm or larger telecommunications line cord
between the DSL jack and the wall.

POTS connector

Use the POTS connector when placing or receiving POTS calls.

USB host connector

Use the USB host connector (USB 2.0) for saving results and configurations, or for firmware
updates.
June 2014
shows the connector panel.
DSL line connector
POTS connector
USB 2.0 connector
Ethernet connector
SmartClass TPS User's Guide
22035456, Rev 001
Chapter 1 Getting Started

Exploring the connector panel

11