Monitoring Pings - JDS Uniphase SmartClass User Manual

Specify the settings. The following table describes the settings.
Setting
Destination Type
IP Address
DNS Name
TX Count
TX Interval
Payload Size
3 Select Ping Test Menu to start the ping and display the test results menu.
Use the # key to stop the test, if desired.
4 To save a test report, press the utility (i) key and then select Save Report or Save To Job,
and then specify the report settings such as report name, report format, technician ID, loca-
tion, and other settings as needed.
For more information on the results, see

Monitoring pings

The Ping Monitor allows you to monitor incoming pings on an active line. This is useful for network
administrators to watch the network states and identify trouble.
To monitor pings
1 From the IP Data menu, select Ping Monitor.
NOTE:
The Ping Monitor is only available when the modem is synchronized and the data layer is active.
2 View the results.
The results include the IP address and number of pings received. The IP address is for the
most recent device detected.
3 To save a test report, press the utility (i) key and then select Save Report or Save To Job,
and then specify the report settings such as report name, report format, technician ID, loca-
tion, and other settings as needed.
June 2014
Description
Specify whether the destination is an IP Address , DNS Name (domain name
server), or IPv6 Address.
IP address uses the numeric address. DNS name uses the domain name,
such as www.jdsu.com.
JDSU recommends using the IP address or DNS name of the ISP gateway of
the customer's service provider
If the destination is IP Address, enter the IP address.
If the destination is DNS Name, enter the DNS name.
Enter the number of pings to send before stopping.
Specify the number of pings per second.
Enter the ICMP Payload Size in Bytes.
The default is 16. Change this only if needed.
"IP Data results" on page
SmartClass TPS User's Guide
22035456, Rev 001
.
126.
Chapter 7 Data testing
Monitoring pings
63