JDS Uniphase SmartClass User Manual page 74

Chapter 6 DSL Testing
Specifying test settings
Setting
Login Mode
WAN VPI / VCI
Encapsulation
PPP Authentication
(TI modem only)
PPP Username
PPP Password
PPP Use Provider
(TI modem only)
PPP Provider
3 Select PTM Operation and then specify the settings. The PTM settings are available if your
unit has a Broadcom modem. It is greyed out if you specified ATM transport mode. The
following table describes the settings.
Setting
Data Mode
IP Mode
IP Addr.
IP Netmask
Gateway
DNS Server
Login Mode
PPP Username
PPP Password
56
Description
Only appears if IP mode is Dynamic, specify whether to automatically or man-
ually login. If set to manual, the data synchronization will not occur until you
login.
Specifies the VPI and VCI for the customer-facing port on the DSLAM.
Select LCC-SNAP or VC-MUX .
If the Data Mode is PPPoE or PPPoA, select the authentication mode
– Auto means that the SmartClass Triple Play Services picks the mode that
matches the far end mode
– CHAP is Challenge Handshake Authentication Protocol
– PAP is Password Authentication Protocol
Enter a valid user name.
This must be a valid user account with an ISP.
Enter the user password.
This must be a valid password that matches the user name above. Pass-
words are often case-sensitive.
Select Yes or No .
This option indicates whether to append the user name with the service pro-
vider domain name (for example, earthlink.net). Select Yes only if user names
for the ISP must include the domain name as part of the user name. This set-
ting automatically appends the @ sign for you.
Enter the provider name.
This is required if you selected Yes for "Use Provider."
Description
Select the network type.
– None turns the data layer off
– IPoE is IP over Ethernet
– PPPoE is PPP over Ethernet
Select either Static or Dynamic (DHCP) if using IPoE.
If the IP Mode is Static, enter the IP address that the tester will use.
If the IP Mode is Static, enter the net mask address.
If the IP Mode is Static, enter the gateway address.
If the IP Mode is Static enter the address of the DNS server.
Only appears if IP mode is Dynamic, specify whether to automatically or manu-
ally login. If set to manual, the data synchronization will not occur until you login.
Enter a valid user name.
This must be a valid user account with an ISP.
Enter the user password.
This must be a valid password that matches the user name above. Passwords
are often case-sensitive.
SmartClass TPS User's Guide
22035456, Rev 001 June 2014