Controlling The Smartclass Tps With A Mobile Device - JDS Uniphase SmartClass User Manual

Chapter 4 Using the SCTPS with a mobile device

Controlling the SmartClass TPS with a mobile device

Controlling the SmartClass TPS with a mobile device
Using an app on the mobile device, you can connect to a SmartClass and control the user interface.
SmartClass TPS supports mobile device applications on both iOS and Android.
To control the SmartClass with a mobile device
1 To configure the SmartClass TPS as a WiFi access point for the mobile device, see
nicating with a mobile device" on page
2 Setup the mobile device to connect to the <product name>'s WiFi network.
a
b
3 On the mobile device, launch the SCTPS app.
The Controller page appears.
From this page, you can select whether to control the <product name> user interface, check video
with Dazzle, or test with SmartIDs.
Across the bottom, icons are available for:
– Controller page–the screen above, allows control of the user interface, launching a video
check, and testing with SmartIDs (see
mobile
– Job Manager–used to manage test results
– Quick Cards–view quick cards (short documents of instructions)
– Manual–read the manual
– Videos–view instructional videos
– Accessories–view the guide for the accessories
For iOS mobile device, if you are controlling the <product name> using an iPhone instead of an
iPad, the screen will appear slightly different: the SmartID app is replaced with the Job Manager
(SmartID tests are only available on the iPad and Job Manager is not an icon at the bottom).
For Android device, the SmartClass TPS GUI is very similar to that of the iOS mobile device.
36
Go to the Settings menu.
Select WiFi and find the SSID for the SmartClass that you wish to connect to.
device", and "Testing with
SmartClass TPS User's Guide
22035456, Rev 001
23.
"Controlling the device
SmartIDs")
"Commu-
interface", "Viewing video on a
June 2014