Table of Contents
Advertisement
Chapter 10 SmartID Testing
Testing the home network
4
On the Main Menu, select SmartID.
5
On the SmartID screen, select Whole Home Check.
6
On the Select SmartID Test Plan screen, select whether to test through a diplexer (RG -
Through Diplexer) or not (RG - No Diplexer).
– For the NID without diplexer configuration (configuration a, above), select RG - No
Diplexer.
– For the NID with diplexer configuration (configuration b, above), select RG - Through
Diplexer.
– For the INID configuration (configuration c, above), select RG - No Diplexer.
7
Begin the test.
After the test completes, the result test summary appears.
Figure 19 Whole Home Test Summary (Example)
The test summary displays the paths between SmartIDs and indicates whether the quality of
the path between the two points is passing or failing based on pre-set limits. The left side of
the screen will show the frequency sweep and noise ingress measurement results for each
highlighted box, which corresponds to the two points between SmartIDs in the coax network.
To view other test results, press the * key and then either use the arrow keys to navigate to
different SmartID results or directly select the desired result: Test Summary, Detailed View,
Network Map, or Sweep Data. For more detail on the results, see
page
8
To save a test report, press the utility (i) key and then select Save Report or Save To Job,
and then specify the report settings such as report name, report format, technician ID, loca-
tion, and other settings as needed.
82
129.
SmartClass TPS User's Guide
22035456, Rev 001
"SmartID results" on
June 2014
Advertisement
Table of Contents
Troubleshooting
