Network Map; Sweep Data; Voip Results; Call Information Results - JDS Uniphase SmartClass User Manual

Chapter 16 Test Results

VoIP results

Network Map

This category shows the layout of the network. The SmartID connected to the <product name> is
on the left and the home network cascades to the right. Use the up and down arrow keys to select
different SmartIDs on the map. Press OK to see details of a particular segment.

Sweep Data

This category shows a graph of the frequency sweep. Use the # key to reverse the direction.
VoIP results
The following section describes the results available in VoIP mode. To view the different categories
of statistics, use either the left and right arrows, or press the number for the desired result category.

Call Information results

Table 38
Table 37 Call Info results
Result
Call Duration
Far End Information
Audio Parameters

Throughput

Table 38
Table 38 Throughput results
Result
Local Audio Bytes
Local Audio Packets

Audio Delay

Table 38
Table 39 Audio Delay results
Result
Incoming Audio Codec
130
describes the Call Information results.
Definition
Length of time for the current call. If the call duration continues beyond
59:59 (meaning, is more than an hour), the display changes from mm:ss to
hh::mm (note the change from : to :: ).
The IP address, ID Name, Alias, and Connect method for the incoming call.
The receive and transmit codec being used, whether RTCP is being used for
the Audio or Video path, and whether silence suppression is enabled.
describes the Throughput results.
Definition
Total number of bytes transmitted (TX) or received (RX)
Total number of packets transmitted (TX), received (RX), lost, or out of
sequence (OOS).
describes the Audio Delay results.
Definition
The audio codec used for the incoming call
SmartClass TPS User's Guide
22035456, Rev 001 June 2014