JDS Uniphase SmartClass User Manual page 61

The following table describes the settings.
Setting
Data Mode
Interface Count
VLAN x Setup (or
IPv6 VLANx Setup)
MAC Addr. Mode
VLAN
VLAN ID
VLAN Priority
IP Mode (IPv4)
IP Addr. (IPv4)
IP Netmask (IPv4)
Gateway (IPv4)
DNS Server
Use DHCP Vendor ID
DHCP Vendor ID
Use User Class
DHCP User Class
IPv6 Mode
DHCPv6 Option
June 2014
Description
Select the data mode.
IPoE is IP over Ethernet
PPPoE is PPP over Ethernet
Multi-VLAN is multiple VLAN; multiple Virtual LANs are used on this net-
work. In this mode, the SmartClass Triple Play Services assumes that the
networks that are accessed via each VLAN are unique, and thus provides
access to a different range of IP addresses. A typical scenario would be
one VLAN for Internet data, another VLAN for Voice, and another VLAN for
Video.
IPv6oE is IPv6 over Ethernet.
To review the basic differences in IPv4 vs. IPv6, see
on page 62
IPv6 Multi-VLAN is multiple VLAN over IPv6 (up to 3 VLANs).
If Multi-VLAN Data Mode is used, specify the number of VLAN interfaces,
up to three.
If Multi-VLAN Data Mode is used, specify the settings for each LAN. On this
menu, the Client Mode specifies the data mode for the VLAN. Other setup
items appear depending on the Client (Data) Mode (such as Use DHCP
Vendor ID, or Username and Password). You must also define a purpose
for IPv4 VLANs 2 and 3
If IPoE or PPPoE Data Mode is used, specify whether the MAC is the fac-
tory default or user defined.
If IPoE or PPPoE Data Mode is used, specify whether VLANs are used.
If VLAN is On, specify the VLAN ID.
If VLAN is On, specify the VLAN Priority.
If IPoE Data Mode is used, select either Static or DHCP (dynamic host
configuration protocol) mode.
If the IP Mode is Static, enter the IP address that the tester will use.
If the IP Mode is Static, enter the net mask address.
If the IP Mode is Static, enter the gateway address.
If the IP Mode is Static enter the address of the DNS server.
Select Yes or No to whether to use the vendor ID.
This is only available if you selected DHCP as the "IP Mode".
Enter the Vendor ID.
This is required if you selected Yes for "Use DHCP Vendor ID."
Select Yes or No to whether to use the User Class.
This is only available if you selected DHCP as the "IP Mode".
Enter the User Class.
This is required if you selected Yes for "Use User Class."
If IPv6oE Data Mode is used, select DHCPv6 (stateful configuration per
RFC 3315) Stateless (auto-configuration per RFC 2462), or Manual mode.
If using IPv6oE and the mode is DHCP, specify whether IA PD (prefix dele-
gation) is used.
SmartClass TPS User's Guide
22035456, Rev 001
Chapter 5 Ethernet TE Testing
(Internet, Video, or Voice)
Specifying the network setup
"About data testing"
.
43