Table of Contents
Advertisement
Chapter 3 Automated Testing
Running the VideoCheck test
A check mark indicates pass; an "X" indicates fail, an exclamation point indicates a marginal
result.
The test stops automatically when complete.
For more information on the other results, see
6
To save a test report, press the utility (i) key and then select Save Report or Save To Job,
and then specify the report settings such as report name, report format, technician ID, loca-
tion, and other settings as needed.
Running the VideoCheck test
The VideoCheck test is used to verify the channels are provisioned as the subscriber requested.
To run the VideoCheck test
1
Launch the desired application: DSL, Ethernet, or WiFi.
2
Select VideoCheck.
The VideoCheck menu appears. From this menu, you can start the test sequence or go to the
setup menu.
If you haven't already specified the settings, press the key to do so. See
3
4
Press the # key to Start the test.
The test begins.
As the test runs, the status and results of the test are displayed. A check mark indicates pass;
an "X" indicates fail, an exclamation point indicates a marginal result.
The test stops automatically when complete.
5
View the results.
The following table describes the VideoCheck results.
Result
Ch
Name
Status
QoS
To view details for a specific stream, highlight the stream/channel, and then press OK.
Details are available for loss, jitter, error ind, join latency, leave latency, and channel settings
such as IP address and stream type.
For more information on the other results, see
6
To save a test report, press the utility (i) key and then select Save Report or Save To Job,
and then specify the report settings such as report name, report format, technician ID, loca-
tion, and other settings as needed.
34
Description
The channel index number. It should match the channel ID configured in the channel
list.
The channel name. It should match the channel name configured in the channel list.
The status of the stream.
Media wait - evaluating the status
Stream up - stream is under test
Available or Unavailable - status after test is done.
A pass/fail indication of the quality of the stream. It only appears if the stream is avail-
able and the test duration is more
SmartClass TPS User's Guide
22035456, Rev 001
Chapter 16 "Test
Results".
than zero seconds.
Chapter 16 "Test
Results".
step e
above.
June 2014
Advertisement
Table of Contents
Troubleshooting
