Avaya AP-4 User Manual page 253

6. Change the IP address and other network values using set and
reboot CLI commands, similar to the example below (use your own
IP address and subnet mask).
Note: The IP Address Type is set to Dynamic by default. If you have a
DHCP server on your network, you should not need to manually
configure the Access Point's IP address; the Access Point will
obtain an IP address from the network's DHCP server during boot-
up.
Result: After each entry the CLI reminds you to reboot; however
wait to reboot until all commands have been entered.
[Device name]>
[Device name]>
[Device name]>
[Device name]>
[Device name]>
[Device name]>
7. After the AP reboots, verify the new IP address by reconnecting to
the CLI and enter a show ip command. Alternatively, you can ping
the AP from a network computer to confirm that the new IP address
has taken effect.
8. When the proper IP address is set, use the HTTP interface or CLI
over Telnet to configure the rest of the unit's operating parameters.
Avaya Wireless AP-4/AP-5 User's Guide
set ipaddrtype static
set ipaddr <IP Address>
set ipsubmask <IP Subnet Mask>
set ipgw <Default Gateway IP Address>
(to confirm your new settings)
show ip
reboot 0
Recovery Procedures
7-27