Basic Panel Key Operation - Clear-Com ECLIPSE EASI-PICO MATRIX User Manual

E a s i - P i c o U s e r G u i d e
RJ-45 Connector to Matrix
Connects to panel to matrix via CAT 5 cabling.
Speaker Mute Level control
This knob adjusts the speaker DIM level when any talk is active at the station;
this function helps prevent possible feedback. The maximum amount of muting
is 15db below full volume. If the rear panel control is set below that level then
muting will have no effect.
Page Override Level Control
This knob adjusts the override level; this feature is not used in the Easi-PiCo
system.
Headset Microphone Sidetone Control
This knob adjusts the headset sidetone level. Sidetone is the sound of the user's
voice in his headset.
Headset and Panel Microphone Gain Controls
These knobs adjust the gain of the headset and panel microphones. The
preamplifier gain of the panel and headset microphone can be adjusted over a
range of 0 to 20 dB.

Basic Panel Key operation

Making Calls (Talk keys)
Each configured Talk button (red) will be dim to indicate it has a programmed
label. When selected it will become bright RED to indicate it is active.
• Choose destination of call and select the key assigned to that destination.
• Push the correct key momentary to latch or push and hold for non latching
key action.
• Then talk. Your command will come out of the destination loudspeaker
automatically (All the talk keys are talk only so the call destination will have
to operate a key to reply).
• The Talk key LED will lit bright Red showing the key is active.
• Release the key to end the call.
Receiving Calls (answering)
• When another panel is calling you will hear the message via the headset or
the internal loudspeaker.
• The panel that is programmed to talk back to the caller will flash red to
indicate the caller.
• To answer this call you can either press the assigned to talk back to that
destination which will be flashing red or by simply pressing the answer-back
key.
Listen Key
3 3