Aux-In Jack - Seat Mii 2020 Owner's Manual

You may also need to manually start play-
back on the Bluetooth® audio source. When
playback ends on the Bluetooth® audio
source, the infotainment system remains in
Bluetooth® mode.
Controlling playback
The extent to which the Bluetooth® audio
source can be controlled via the Infotainment
system depends on the Bluetooth® audio
source that is connected.
With media players that support the AVRCP
Bluetooth® profile, playback on the Blue-
tooth® audio source can be automatically
started or stopped when the unit is switched
to Bluetooth® Audio mode or to a different
audio source. In addition, it is possible to view
or change the track via the Infotainment sys-
tem.
WARNING
Do not perform the pairing and connection
process while driving. This may cause an
accident!
Note
Due to the large number of possible Blue-
●
tooth® audio sources, it is not possible to
guarantee fault-free operation of all de-
scribed functions for all these sources.
To operate the media and phone with the
●
connected Bluetooth® device, please read
124
Infotainment System
the manufacturer's electronic Instructions
Manual.
Only use compatible Bluetooth® devices.
●
You can request information about compat-
ible Bluetooth® products at a SEAT Author-
ised Service or online.
External audio source connected to
the AUX-IN multimedia socket
The AUX-IN multimedia jack can be found on
›››
the front of the radio page 109. It can only
be used with a 3.5 mm jack connector.
A connected external audio source is played
over the vehicle speakers andcannot be
controlled via the radio system controls.
The AUX-IN multimedia connection must be
activated in the system settings so it can be
displayed on the Media selection menu
›››
page 121.
Connecting an external audio source to
the AUX-IN multimedia socket
Lower the base volume on radio.
●
Connect the external audio source to the
●
AUX-IN multimedia socket.
Start playback on the external audio
●
source.
In the Media mode, press the
●
ment button to display the Media source se-
›››
lection menu again page 121.
Press the function button.
●

The output volume of a connected external
audio source should be adjusted to the vol-
ume of the other audio sources.
Adapting the playback volume
If you need to increase the playback volume
for the external audio source, first lower the
base volume on the radio system.
If the sound from the external audio source is
too low, increase the output volume on the
external audio source, if possible. If this is not
enough, adjust the input volume in the sys-
tem settings to Level 2 or Level 3 .
If the sound from the connected external au-
dio source is too loud or distorted, lower the
output volume on the external audio source,
if possible. If this is not enough, change the
input volume to Level 2 or Level 1
Note
When the playback from the external au-
●
dio source ends or the connection to the
AUX-IN socket is interrupted, the radio goes
back to the AUX menu.
Interference noise may be heard if the ex-
●
ternal audio source is powered from the 12-
volt power socket of the vehicle.
equip-
