Seat Mii 2020 Owner's Manual page 100

WARNING
Improper use of the socket or electrical de-
vices could lead to a fire and cause serious
injuries.
Never leave children unsupervised in the
●
vehicle. The socket and equipment con-
nected to it can be used when the ignition is
switched on.
Should a connected electrical device
●
overheat, switch it off and unplug it imme-
diately.
CAUTION
Take into account the operating instruc-
●
tions of the devices to be connected!
Never exceed the maximum power rating
●
as this could damage the vehicle's general
electrical system.
To avoid damaging the vehicle's electri-
●
cal system, never connect accessories
supplying power such as solar panels or
battery chargers for charging the 12-volt
battery to the 12-volt power socket.
Only use accessories with approved
●
electromagnetic compatibility according
to current regulations.
To avoid damage due to voltage fluctua-
●
tions, switch off all devices connected to
the 12 V power sockets before switching the
ignition on or off and before starting the
drive system.
98
Operation
Never connect an appliance to the 12 volt
●
power socket that consumes more than the
power indicated in watts. Exceeding the
maximum power absorption could damage
the vehicle's electrical system.
Note
Unshielded equipment can cause inter-
●
ference on the radio equipment and the ve-
hicle's electrical system.
Interference can occur on the radio's AM
●
waveband if electrical appliances are used
near the aerial.
Smartphone support
Portable smartphone holder
Assembling the universal support and
Fig. 106
the holding arm.
In the centre console: close the com-
Fig. 107
partment where the infotainment system is
housed.
Removing the smartphone
Grip the smartphone firmly with one hand.
●
›››
Press the release button Fig. 107
●
the top arm of the universal holder disengag-
es.
Remove the smart phone and, as the case
●
may be, unplug any cables.
Inserting a smart phone
If necessary, install the smartphone hous-
●
›››
ing .
Connect the smartphone.
●
Place the smartphone on the bottom
●
mountings. To adjust the bottom mountings,
›››
press button Fig. 107 .
4
until
5