Seat Mii 2020 Owner's Manual page 167

Pausing or ending the charging process
Press the charging mode button
to pause the charging process. The charging
connector remains locked. The charging
process can be reactivated by pressing the
charging mode button again.
If you wish to unplug the charging connector,
unlock the vehicle using the key.
If the charging ends automatically and the
high-voltage battery is charged:
Unlock the vehicle with the ignition switch-
●
ed off.
Remove the charging connector from the
●
charging socket within 30 seconds.
Unplug the charging cable from the power
●
supply source.
If available, replace the protective caps.
●
Close the cover of the battery charging
●
socket until you hear it has engaged.
Charging for the first time and charging
after not being used for a long period of
time
When the high-voltage battery is new or has
not been charged for a long period of time, it
is possible that the battery may not reach its
maximum charge level until it is charged sev-
eral times. This is due to technical reasons
and has nothing to do with any fault in the ve-
hicle.
High-voltage battery
If you are not going to use the vehicle for a
long period of time, make sure you charge the
›››
Fig. 150
high-voltage battery within a period of 4
months at the latest.
Note
If once the charge is completed you leave
the charging cable connected, the high-
voltage battery will not discharge due to
the use of the vehicle's electricity consum-
ers.
Fast charge at a charging station
(CC)
Behind the cover of the battery charg-
Fig. 151
ing socket: charging socket (schematic repre-
sentation).
›››
Key to Fig. 151
Charging process display
1
Charging socket
2
Protective caps
3
Depending on the equipment, the vehicle can
be charged with direct current (DC) at a
charging station.
Take into account the general information re-
lating to charging the high-voltage battery
and the preparations to be carried out before
›››
charging page 158.
Before charging the battery, always discon-
›››
nect the drive system page 137.
Connecting the charging cable
Fast charge is carried out through the con-
nection located at the bottom of the charging
socket.
Remove the charging cable from the
●
charging station.
With the vehicle unlocked, press the cover
●
of the battery charging socket, located on
›››
the side panel, to open it Fig.
Remove the two protective caps from the
●
›››
charging socket Fig. 151 . To remove the
3
bottom protective cap, first remove the top
cap.
Plug the charging connector into the
●
›››
charging socket Fig. 151 .
2
151.
»
165