Seat Mii 2020 Owner's Manual page 82

The "Leaving Home" lighting switches off
in the following cases:
Automatically, when the "Leaving Home"
●
delay period ends (default 30 sec).
When the vehicle is locked using the remote
●
control.
When the light switch is turned to position
●
With the ignition is switched on.
●
Note
To activate the "Coming Home" and "Leav-
ing Home" function, the rotary light switch
must be in position and the light sensor

must detect darkness.
Hazard warning lights
Dash panel: hazard warning lights
Fig. 81
switch
80
The hazard warning lights are used to draw
the attention of other road users to your vehi-
cle in emergencies.
If your vehicle breaks down:
1. Park your vehicle at a safe distance from
moving traffic.
.

2. Press the button to switch on the hazard
warning lights
3. Switch the ignition off.
4. Apply the handbrake.
5. Move the selector lever to position P.
6. Use the warning triangle to draw the at-
tention of other road users to your vehicle.
7. Always take the vehicle key with you when
you leave the vehicle.

All turn signals flash simultaneously when the
hazard warning lights are switched on. The
two turn signal turn signal lamps
turn signal lamp in the switch
the same time. The simultaneous hazard
warning lights also work when the ignition is
switched off.
WARNING
The risk of an accident increases if your ve-
hicle breaks down. Always use the hazard
warning lights and a warning triangle to
draw the attention of other road users to
your stationary vehicle.
Operation
›››
.
and the
 
will flash at

Note
The battery will run down if the hazard
●
warning lights are left on for a long time,
even if the ignition is switched off.
The use of the hazard warning lights de-
●
scribed here is subject to the relevant stat-
utory requirements.
Light range control
Next to the steering wheel: headlight
Fig. 82
range control.
›››
The headlight range control
modified according to the value of the head-
light beam and the vehicle load status. This
offers the driver optimum visibility and the
headlights do not dazzle oncoming drivers
›››
.
The headlights can only be adjusted when
the dipped beam is switched on.
Fig. 82 is