Seat Mii 2020 Owner's Manual page 146

CAUTION
If the vehicle needs to be towed, leave the
ignition on so that the steering wheel is not
blocked and the turn signals, the horn and
the windscreen wiper work.
Control lamp
 It lights up red
Stop driving! The electromechanical steering is

faulty.
Have the steering checked immediately by a special-
ised workshop.
 It lights up yellow
The operation of the electromechanical steering is
limited.
Have the steering checked immediately by a special-
ised workshop. If the warning lamp does not come on
again after restarting the engine and driving a short
distance, it is not necessary to check the steering.
The 12-volt battery was disconnected and reconnec-
ted. Drive a short distance at 15-20 km/h (9-12 mph).
Several warning and control lamps light up
for a few seconds when the ignition is switch-
ed on, signalling that the function is being
verified. They will switch off after a few sec-
onds.
144
Driving
WARNING
›››
Observe the safety warnings
trol and warning lamps on page
Driving profiles
Introduction
By means of the driving profiles, the driver
can adapt different characteristics of the ve-
hicle systems to the current driving situation
and to an economic driving style. Among the
systems that can be adapted are, for exam-
ple, engine management and air condition-
ing.
The degree of influence of the vehicle config-
uration on the different driving profiles de-
pends on the vehicle's equipment.
You can change the driving profile both with
the vehicle stopped and while in motion
After selecting a driving profile, the vehicle,
except the engine, is immediately configured
according to the new profile. When traffic
permits, briefly remove your foot from the ac-
celerator so that the selected driving profile is
also activated for the engine.
WARNING
in Con- Adjusting the driving profile while driving
66. can distract attention from traffic and
cause accidents.
Always drive as carefully and responsibly
●
as possible.
Adjusting a driving profile
In the lower part of the centre con-
Fig. 138
sole: driving profile selection button.
›››
.
Selecting a driving profile
Switch the ignition on.
●
To change the driving profile, press the driv-
●
ing profile select button
times.
When changing the driving profile, a message
is is displayed on the instrument panel dis-
play for a few seconds.
›››
Fig. 138 several