Attaching Outer Pieces To The Rail Brackets; Attaching The Rail System To The Rear Rail Bracket - Intel SR2100 Product Manual

6. Attach the side rail system's outer pieces (total of two) to the rail brackets you installed in
step six.
To attach the front part of an outer piece to a rail bracket, you must reveal the access hole
(Figure 34, A) by sliding the innermost piece toward the back. Once you see the access hole,
align it with the hole in the rail bracket (B) such that you can secure the bolt. Insert the screw
through the rail and the front hole in the bracket. Then put the nut on the backside of the rail
bracket.
7. To attach the rear part of the rail system to the rear rail bracket (Figure 35, A), slide the rail
system within the rail brackets such that you can place a bolt through the rail's hole (B) and
into the rail bracket's slot. Tighten the bolt and nut.
Figure 35. Attaching the Rail System to the Rear Rail Bracket
NOTE
For a very deep cabinet, you might need to move the front screw used in the front
bracket to one of the bracket slots. If you do use slots instead of holes in the
brackets, be sure to use the same rail positions for both sides.
50
Figure 34. Attaching Outer Pieces to the Rail Brackets
C
B
C
A
B
OM09138
A
OM09144
Intel SR2100 Chassis Subassembly Product Guide