Adding Components to the Server Board
After installing the server board, you must add the desired number of processors and memory cards.
See the documentation that shipped with your server board for instructions.
Reattaching the Cover
Once the server board and its components are installed, you are done assembling the system unless
you have optional peripherals or add-in cards you wish to install. If you need to install these
components, continue on to the next section. Otherwise, reattach the cover and continue on to
Chapter 4, which describes how to install the system in a cabinet.
To reattach the cover:
1. Place the cover on the chassis and slide it forwards as far as possible.
2. Tighten the two screws on the rear of the chassis.
Assembling the System
A
Figure 15. Installing the Riser Card
OM11054
33