Rear-End Bearing; Disassembling The Rear-End Bearing - Alamarin Jet COMBI-FRAME AJ 285 Repair Manual

Main shaft and bearing
Repair manual
5. Install the stator (section 6.3.
nozzle (section 5.1.3.
reversing deflector (section 4.1.3.
41)
6. Install the hydraulic pump (section 4.3.3.
56).
2.2. Rear-end bearing
2.2.1. Disassembling the rear-end bearing
Rear-end bearing disassembly:
1. Remove the stator (section 6.1.
2. The rear bearing housing is attached to the stator with three screws
(figure 27). Undo the screws and remove the plastic cover.
Figure 27. Rear bearing housing screws
3. Screw one or, if necessary, two of the fastening screws into the threaded
holes in the bearing housing flange.
KM/285/EN/1.1.0
Installing the stator
Installing the steering nozzle
Installing the reversing deflector
Removing the stator
, page 69), the steering
, page 61) and the
Installing the hydraulic pump
, page 65).
, page
, page
19