Launching The Upgrade; Checking New Upgrade On Viavi Server - Viavi 6000A V2 User Manual

Chapter 16 Maintenance and Troubleshooting
Maintenance procedure
Launching the
upgrade
Checking new
upgrade on Viavi
Server
148
NOTE
A bip is emitted each time the USB memory stick is inserted or
removed from the USB port.
H
6 Press the
OME
Upgrades > Software Upgrade > Upgrade from
The message Are you sure? is displayed
7 Click on Confirm.
The list of the software versions available on the USB stick is
displayed next to the versions installed on the 6000A V2 Platform
(see Figure 94 on page
Whatever is the method selected for upgrade (Server, USB key...) and
once the list of the software versions available is displayed next to the
versions installed on the 6000A V2 Platform (see
page 146), follow these instructions to launch the upgrade:
1 Click on Show
previous and next versions available.
2 Click on Confirm this Choice
software(s).
or
Click on Confirm All Choices to upgrade all versions.
NOTE
The software versions list does not always appear (cf previous ver-
sions) as well as the
firm/Continue key. In this case, the upgrading starts automatically.
Upgrading begins. The 6000A V2 Platform is automatically
rebooted. Upgrading takes several minutes. Finally, the 6000A V2
Platform is automatically restarted.
During the upgrade, the Testing indicator is lit in red. Do not
push any button or remove the USB memory stick while the
indicator is lit. The USB stick can be removed if necessary once
the Testing indicator is off.
If the Viavi Server is selected for upgrade (see
the parameter Check new release can be defined to automatically
inform user of a new upgrade available for Platform.
1 In the System Settings screen, select Upgrade parameters
User Manual 76100000200 Rev. 001
hard key, then successively
146).
Prev choice or Show
to start the upgrade of the selected
Previous / Next Choice
Expert Tools >
USB.
Figure 94 on
Next Choice to display the
buttons and the
Figure 93 on page
Con-
145),