Starting Up With The Scope; Freeze Mode - Viavi 6000A V2 User Manual

Starting up with the scope

Freeze mode

Once the FiberScope icon is validated:
1 Press R
ESULTS
Focus level for
image sharpness
Fig. 18 Example of the result using the P5000i scope
Use the Focus Control button onto the P5000i scope (see
page 36) to adjust the image quality and sharpness.
NOTE
To switch from Scope page to FO results page and vice-versa, press
the R hard key for about 2 seconds (a beep is emitted).
ESULTS
Once the image is acceptable, you may
allows to store in memory the resulting picture.
Freezing a scope result does not store the picture in a file (see
menu" page 46). The result will be lost if the instrument is shut off, or if
more than 3 pictures are frozen (see
NOTE
The button set on the lead, or the QuickCapture™ on the P5000
allows to freeze the picture, and to launch a test (according to config-
uration in Setup page - see
User Manual 76100000200 Rev. 001
hard key
"Mosaic Mode" page
"Configuring the Scope" on page
Chapter 6 Scope

Starting up with the scope

Figure 14 on
freeze the picture. This feature
"File
44).
37).
41