Safety - Fronius Robacta Reamer X-Line J Operating Instructions Manual

Safety

Safety Follow the safety rules below when carrying out all the tasks described in the
"Troubleshooting" chapter.
Danger from incorrect operation and work that is not carried out properly.
This can result in severe personal injury and damage to property.
▶
▶
▶
Danger due to machines starting automatically.
This can result in severe personal injury and damage to property.
▶
Danger due to moving mechanical parts, flying debris (chips, etc.), and com-
pressed air/parting agent mixture discharged from the parting-agent injection
nozzle.
This can result in severe personal injury and damage to property.
▶
▶
If the cleaning device is supplied with voltage and/or compressed air, there is a
risk of serious injury from: rotating cleaning cutter, cleaning motor moving up/
down, gas nozzle clamping device moving out/in, activated wire cutter, flying parts
(chips, etc.), compressed air/parting agent mixture escaping from the parting-
agent injection nozzle.
This can result in severe personal injury and damage to property.
If work is required on the cleaning device while the cleaning device is being supplied with
voltage and/or compressed air, take the following safety measures.
▶
▶
▶
WARNING!
All the work and functions described in this document must only be carried out by
trained and qualified personnel.
Read and understand this document.
Read and understand all the Operating Instructions for the system components,
especially the safety rules.
WARNING!
In addition to these Operating Instructions, observe the safety rules of the robot
manufacturer and welding system manufacturer. For your personal safety, make
sure that all protective measures have been taken in the robot's operating area and
remain in effect while you are in this area.
WARNING!
Before carrying out any work, disconnect the customer's compressed air and power
supply from the cleaning device and the associated system components and make
sure that the compressed air and power supply remain disconnected until all work
has been completed.
Before carrying out any work, ensure that the cleaning device is depressurized - the
necessary steps for this can be found in the following section
cleaning device is depressurized
WARNING!
Keep your body, especially hands, face and hair, as well as objects and all items of
clothing away from the cleaning cutter, cleaning motor, lifting device, gas nozzle
clamping device, wire cutter, and parting-agent injection nozzle.
Wear hearing protection.
Wear protective goggles with side protection.
from page 62
Ensuring that the
61