Table of Contents
Advertisement
Service, maintenance and disposal
General
The cleaning device does not usually require maintenance. To ensure the cleaning
device remains operational over time, there are a number of care and maintenance tasks
that need to be carried out, however:
Before every
-
start-up
-
-
-
-
-
Daily
Danger due to cleaning agents containing solvents.
This can result in damage to property.
▶
1
Weekly
NOTE!
Only clean the parting agent container with cleaning products that are free of
solvents.
-
-
Every 6 months
1
Whenever
Open the device and
required
1
2
3
Check the fill level in the parting agent container and top up the parting agent con-
tainer if necessary
Check the fill level in the parting agent collecting container and drain the parting
agent collecting container if necessary
Check for wear of the cleaning cutter and replace the cleaning cutter if necessary
Drain the cleaning device's collecting container
Drain the wire cutter's collecting container, if present
In general, you should visually inspect the cleaning device and ensure that any dam-
age is repaired immediately (before commissioning)
CAUTION!
Only clean the cleaning device with cleaning products that are free of solvents.
Remove deposited parting agent and contamination from the device
Check the parting agent container and parting agent collecting container for contam-
ination and clean if necessary
Blow out the intake filter in the parting agent container from the inside out with com-
pressed air using the intake hose ("Starting Up the Parting Agent Atomizer" chapter)
Open the device and check the pneumatic valves to ensure
-
No leaks
-
All screws are screwed tightly in place
-
All screw joints are fixed firmly in place on the pneumatic valves
Blast the inside of the device clean with dry and reduced compressed air
Lightly oil the guides on the lifting device's lifting cylinder
Restore the original state of the device
57
Advertisement
Table of Contents
Troubleshooting
