Ensuring That The Cleaning Device Is Depressurized - Fronius Robacta Reamer X-Line J Operating Instructions Manual

Danger due to hot cleaning cutter as a result of operation.
Serious burns may result.
▶
Ensuring that the To ensure that the cleaning device is depressurized, try to briefly activate the cleaning
cleaning device device without the compressed air supply. To do this, proceed as follows:
is depressurized
1
2
3
56
CAUTION!
Before handling the cleaning cutter, allow it to cool to room temperature (+25 °C,
+77 °F).
Take protective measures:
- The cleaning cutter, lifting device, gas nozzle clamping device, wire cutter, and
parting-agent injection nozzle could be activated. Therefore, keep your body,
especially hands, face and hair, as well as objects and all items of clothing,
away from the aforementioned parts
- Wear hearing protection
- Wear protective goggles with side protection
Ensure that the cleaning device is disconnected from the compressed air supply
Briefly turn the "Lifting device up/down" screw on the cleaning device 90° to the right
and immediately back to the starting position
- If the cleaning device does not react to the rotation of the screw, the cleaning
device is depressurized
- If the cleaning device reacts to the rotation of the screw, the cleaning device is
still connected to the compressed air supply.
In this case, make sure that the cleaning device is disconnected from the com-
pressed air supply before starting any work and then ensure that the cleaning
device is depressurized