3
Setting the injec-
NOTE!
tion quantity of
To correctly set the injection quantity, the welding torch must be in the cleaning
the parting agent
atomizer
position.
1
2
3
4
5
Fine-tune the injection quantity on the parting agent adjusting controller
40
Connect the cleaning device's compressed air supply
Connect the device to the robot control
Activate the injection process using the robot control and check whether the injection
quantity is adequate
If the injection quantity is not adequate, adjust the injection quantity as required
-
use the robot control to adjust the injection time; an injection time of ~ 0.7
seconds is recommended
-
or using the parting agent adjusting controller as illustrated below