Emc Measures; Emf Measures; Safety Measures At The Setup Location And During Transport - Fronius Robacta Reamer X-Line J Operating Instructions Manual

EMC Measures

In certain cases, even though a device complies with the standard limit values for emis-
sions, it may affect the application area for which it was designed (e.g., when there is
sensitive equipment at the same location, or if the site where the device is installed is
close to either radio or television receivers).
If this is the case, then the operating company is obliged to take appropriate action to
rectify the situation.
Check and evaluate possible problems and the interference immunity of equipment in
the vicinity according to national and international regulations:
-
-
-
-
Supporting measures to avoid EMC problems:
1.
2.
3.
4.

EMF measures

Electromagnetic fields may cause health problems that are not yet known:
-
-
-
-
Safety Measures A toppling device can be deadly! Install the device horizontally on a flat, stable surface
at the Setup Loc- free of vibration, anchor it securely on the surface, and secure against toppling.
ation and during
Special regulations apply in areas at risk of fire or explosion
Transport
-
Use instructions and checks within the company to ensure that the vicinity of the work-
place is always clean and organized.
Take care to ensure that the applicable national and regional guidelines and accident
prevention regulations are observed when transporting the device, especially guidelines
concerning hazards during transport and shipment.
It is essential to conduct a visual inspection of the device to check for damage after it has
been transported but before it is commissioned. Have any damage repaired by trained
service technicians before commissioning the device.
8
Safety devices
Grid power lines, signal lines, and data transfer lines
EMC and telecommunications equipment
Devices for measuring and calibrating
Grid power supply
- If electromagnetic interference occurs despite a grid connection that complies
with regulations, take additional measures (e.g., use a suitable grid filter).
Control lines
- Keep them as short as possible
- Route them close together (also to avoid EMF problems)
- Route them far from other lines
Equipotential bonding
Shield, if necessary
- Shield other devices in the vicinity
- Shield the entire welding installation
Effects on the health of persons close by, e.g., those with pacemakers and hearing
aids
Persons with pacemakers must seek advice from their doctor before staying in the
immediate vicinity of the device and the welding process
Keep distances between welding cables and the head/torso of the welder as large
as possible for safety reasons
Do not carry welding cables and hosepacks over one's shoulder or wrap them
around one's body or body parts
Follow the appropriate national and international regulations.