Table of Contents
Advertisement
Figure 7-1. U-Tube.
10. Remove the elbow fitting from the end of the inlet tube assembly by
loosening the Swagelok nut. Use a backup wrench.
11. Remove the inlet tube (Figure 7-2) from the furnace by turning the T-
fitting on the inlet tube assembly counterclockwise until you can pull
the assembly out of the furnace. Push the cell towards the furnace and
away from the cell inlet tube until the cell detaches from the cell inlet
tube. This will allow you to remove the inlet tube assembly from the
analyzer.
Cell
O-Ring
Cell
Spacer
Figure 7-2. Inlet Tube Assembly.
Figure 7-3.
Furnace assembly.
Silicon
Seal
T-Fitting
Cell
Cell
Contact Clip
Inlet Tube
Elbow
Fitting
Swagelok
Nut
Port
Connector
|
Parts Replacement
7-3
Advertisement
Table of Contents
