Alarm Key - Ametek Thermox CG1000 User Manual

Alarm Key

Figure 4-3. Alarm Key menu options.

NOTE
Alarm Key Menu
Alarm Set Points
Select Function
Alarm Configure
Relay Configure
Select Function
Exception Log
ALARM KEY
Alarms 1 and 2 are hard wired for the watchdog and service alarms
and are therefore not selectable in software.
Functions/Options
Define whether Alarm 3 activates based on oxygen, flow,
the start of a calibration or the start of a verification (Select
function). Alarm 4 is always an oxygen alarm.
Define whether Alarms 3 and 4 should be a high or low
alarm.
Define whether alarm relays should energize or de-ener-
gize on alarm.
The selection you make here applies to all alarms except
the Watchdog and Service alarms which always de-ener-
gize on alarm.
Define whether Alarm 3 activates based on oxygen levels,
start of calibration, or start of a verification.
View Exception Log data.
Provides a history of events such as system or error mes-
sages, alarm conditions, and the start of calibrations or
verifications.
Alarm Set Points
Alarm Configure
Relay Configure
Select Function
Exception Log
Controller / User Interface
|
4-19