Filter Change - Weinmann homecare SOMNOsoft + WM 24600 Description And Operating Instructions

9.2 Filter change

Please use only original Weinmann filters. Using third-party filters can render the guarantee
void and may result in adverse effects on the functioning and biocompatibility of the
device.
Coarse dust filter
1. To ensure that no water runs into the SOMNOsoft + when changing the filters, discon-
nect the humidifier
Fine filter
1. Remove the coarse dust filter as described above.
2. Remove the fine filter.
3. Check the filter for soiling.
Coarse dust
Fine dust
filter
filter
If the fine filter is changed because of soiling before 250 operating hours are reached, the
hour counter must be reset to zero:
26 Servicing
from the device. Also observe the operating instructions supplied.
34
2. Slightly raise the rear of the SOMNOsoft + or push the
back of the device off the edge of the table a little, so
that you can reach under the filter cover
3. Press the bottom edge of the cover with your finger and
lift it off.
4. Remove the coarse dust filter.
5. Insert the clean coarse dust filter.
6. Insert the filter cover in the opening in the housing with
its upper edge first.
7. Using a finger to press in the catch on the underside of
the cover, fit the cover so that it clicks into place.
The fine filter must be changed if it has turned dark grey,
and in any case after 250 operating hours. In that case the
filter change symbol
4. Replace the filters and the filter cover in reverse order.
5. To clear the filter change symbol, hold down the on/off
button
bol disappears from the display.
appears.
18
when switching on the device until the sym-
24
.
28