Replacing Parts - Angelo Po 090BM1G Use And Installation Manual

RECOMMENDATIONS FOR REPLACING PARTS
Before carrying out any replacement procedure, ac-
tivate all the safety devices p rovided and decide
whether staff at work and those in the
should be informed. In particular, turn off the gas
and water supply taps, cut off the electricity supply
to the appliance using the master switch and pre-
vent access to all devices which might cause unex-
pected health and sa fety hazards if turned on . If
REPLACEMENT OF THE BURNER NOZZLE
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the scr ews (B) and remo ve the control
panel (C).
4 - Unscrew the nozzle (D) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
5 - Replace the control panel (C) and the knob (A)
on completion of the operation.
REPLACING THE BURNER AIR BUSHING (190BM2G)
To carry out this operation, proceed as follows.
1 - Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the scr ews (B) and remo ve the control
panel (C).
4 - Undo the screw (D).
5 - Extract the bushing (E) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
6 - Tighten the screw (D).
7 - Replace the control panel (C) and the knob (A)
on completion of the operation.

REPLACING PARTS

vicinity
- 21 -
worn parts have to be replaced, use original spare
parts only. The manufacturer declines all responsi-
bly for injury or damage to components du e to the
use of non or iginal parts, or extraordinary work on
the appliance which may modify the safety require-
ments without the manufacturer 's authorisation.
When ordering components, follow the instructions
provided in the parts catalogue.
A
B
B
C
A
B
B
C
9
IT
D
GB
IDM-39615801700.tif
DE
FR
ES
E
D
IDM-39615801800.tif
English