Optional Accessories - Nortek Security & Control 2GIG e Series Installation And Programming Manual

Wireless security system

Hide thumbs Also See for 2GIG e Series:

Table of Contents

GC2e Wireless Security System | Installation and Programming Guide

Optional Accessories

Optional modules, keypads, radios, and sensors that can be purchased to enhance the system include:

•

2GIG LTE (Cellular) Radio Module. An on-board digital communicator reports alarms and trouble to a Central Station

receiver and a two (2)-way voice communication with the Central Station. It also supports OTA updates and remote

control of the system using a Web-enabled device through the Internet.

•

2GIG 900 MHz Transceiver Module . It sends and receives signals with wireless touch screen keypads and image

sensors . Touch screen keypads allow remote control of the system through the same graphic interface design as the

2GIG Control Panel. Note that the 2GIG 900 MHz Transceiver Module, touch screen keypad, and image sensor are only

available in some regions .

•

2GIG Wireless Touch Screen Keypad. A wall-mounted, full-color, touch screen interface that provides many of the

same easy-to-use keypad functions available on the Control Panel. It is designed for indoor use only and gives users

the ability to control lights, thermostats, and door locks, as well as to view the status of every sensor zone . When the

2GIG 900 MHz Transceiver Module is installed in the Control Panel, the system can be programmed to communicate

with up to four (4) Wireless Touch Screen Keypads .

•

2GIG Go!Bridge IP Communicator. The Go!Bridge provides Internet connectivity between the monitoring service's

Central Station and the Go!Control® Panel (requires the 2GIG 900 MHz Transceiver Module and supports automatic

firmware updates, provides interactive security services, and increases supervision using signal-forwarding to the

Central Station.

•

2GIG Super Switch Takeover Module . The takeover module communicates with the 2GIG Control Panel and is

designed to convert up to eight (8) pre-wired zones to supervised wireless zones.

•

2GIG Hardwire Conversion Kit. This kit provides installers with an easy way to convert the zones of a pre-wired

security alarm system to 2GIG wireless zones . The kit includes one (1) Super Switch Takeover Module (Wireless

Takeover of an Alarm System, US Patent No. 8,638,218). You can also install two (2) additional modules, which

provides installers with the capability to convert up to 24 pre-wired security zones to wireless zones.

Introduction

Table of Contents

Do you have a question about the 2GIG e Series and is the answer not in the manual?

Gc2e