Key Fob Programming Outline; Q3: Rf Key Fob Programming Outline; Summary Of Rf Key Fob # Screen; Rf Key Fob Programming Questions - Nortek Security & Control 2GIG e Series Installation And Programming Manual

GC2e Wireless Security System | Installation and Programming Guide

Key Fob Programming Outline

Q3: RF Key Fob Programming Outline

Figure 49
Key Fob Programming Outline
Scroll between op ons using the ← and → arrows. Move to
the previous or next prompt by tapping the ↑ and ↓ arrows.
To program another sensor tap Next .
1.
To exit programming, tap Skip, then End, and then Exit .
2.
Upon exit, the panel takes several seconds to restart .
TIP:
3. Tap Skip to jump to question Q4. See
Programming Questions" on page

Summary of RF Key Fob # Screen

After setting all the options for a key fob, the Summary of Fob #
screen is displayed . The screen can also be displayed for programmed
keyfobs during keyfob program editing by tapping the Sum button.
•
•
•

RF Key Fob Programming Questions

Q3: Select Fob # (1 to 8)
Up to eight (8) wireless four (4)-button key fobs can be used with
each Control Panel. Key fobs reports as sensors 51-58. The options for
each fob are programmed with sub-option questions.
• Begin by entering the fob number or select it using the ← or
• Program the key fobs by using ↑ and ↓ arrows to select the
NOTE: To skip RF key fob programming, tap Skip to jump from
question Q3 to question Q4 (RF keypad programming). See
Keypad Programming Questions" on page
Q: Select Fob # Used (0 to 1)
DEFAULT: (0) Unused
Key fobs can be used with the Control Panel or not .
• The default setting (0) Unused sets all key fobs as unused .
• To en able programming for this key fob, select (1) Used .
Q: Select Key Fob # Equipment Code (0-9999)
DEFAULT: (0000) Other
The key fob equipment code defines the sensor's manufacturer and
type .
• The default setting is (0000) Other .
• Select (0866) 2GIG 4‐button Key Fob remote for a 2GIG-KEY2
• Select (0577) Existing Key Fob for an existing key fob remote.
NOTE: Only 2GIG 4-Button Key Fob Remotes are compatible with this
system .
Q: Enter Key Fob # Other Equipment Code (0-
9999)
DEFAULT: 0
NOTE: This question is only displayed if (0000) Other is selected for a
key fob's equipment code .
• The equipment code is a four (4)-digit code that is assigned to
• Enter the equipment code number for the key fob .
"RF Keypad
47 .
While programming each key fob remember that the ← and →
arrow bu ons step through each of the key fob numbers .
To return to programming, tap the Edit Current or Edit Next
buttons.
Tapping Skip goes to question number Q4 (RF Keypad
Programming) . See "Wireless (RF) Keypad Programming" on
page 46 .
→ arrows.
sub-options.
key fob remote .
the model of key fob being used .
Copyright © 2018 Nortek Security & Control
Installer Programming
"RF
47 .
45