GC2e Wireless Security System | Installation and Programming Guide
Restore Default System Configuration
You can restore the Control Panel settings back to its factory
defaults. There are two (2) types of reset options: Soft and
hard .
Soft Reset
A soft‐reset lets you select which settings to restore back to
the factory defaults .
To perform a soft-reset:
At the Installer Toolbox screen, tap the Restore Default
1.
button. The Restore Default System Configuration
screen appears .
Figure 64
Restore Default System Configuration Screen
At the Restore Default System Configuration screen,
2.
select one or both check-boxes:
. Place a check-mark in this box to replace data for
•
Zones
ALL sensors with the factory default values .
AND/OR
•
Console. Place a check-mark in this box to replace all of
the programming answers with the factory defaults . This
erases the user codes, resets the backlight timeout to five
(5) minutes, and resets the Brightness/Volume settings.
IMPORTANT: This action does not restore the factory default
settings for Z-Wave questions Q79-Q83.
Hard Reset
A hard‐reset restores all of the programming settings back to
the factory defaults .
NOTE: Be fore performing a hard reset, Q44: Lock Installer
Programming must be set to option (1) or (2) and Q45: Lock
Default Programming must be set to (0). See
Installer Programming (0-2)" on page 52.
To perform a hard reset:
Remove the Control Panel cover and completely
1.
disconnect all power to the Control Panel .
On the inside back of the Control Panel, plug in the
2.
backup battery.
Tap and hold down the Emergency
3.
buttons.
Continue to hold down the Emergency
4.
buttons and then connect DC Power to the Control
Panel .
Release the buttons only after both the Emergency
5.
and Home
buttons are lit and the Control Panel
screen appears .
"Q44: Lock
and Home
and Home
Copyright © 2018 Nortek Security & Control
Installer Testing
63
Need help?
Do you have a question about the 2GIG e Series and is the answer not in the manual?