Switching The Laser Output On And Off (Laser); Selecting The Laser Diode Polarity (Ldpol); Programming The Laser Diode Software-Limit (Limc) - THORLABS ITC8 Series Operation Manual

_________________________________________________________________________________

3.2.9 Switching the laser output on and off (LASER)

Programming:
":LASER ON"
":LASER OFF"
Reading:
":LASER?"

3.2.10 Selecting the laser diode polarity (LDPOL)

Programming:
":LDPOL AG"
":LDPOL CG"
Reading:
":LDPOL?"

3.2.11 Programming the laser diode software-limit (LIMC)

Programming:
":LIMC:SET <NR3>"
Reading:
":LIMC:SET?"
":LIMC:MIN?"
":LIMC:MAX?"
":LIMC:MIN_W?"
":LIMC:MAX_W?"
(Refer to Chapter 1.5.2, "Software limits I
_____________________________________________________________________________________________________
© 2010 Thorlabs
Switches the laser output on
Switches the laser output off
Reads status of the laser output
[:LASER ON<LF>]
[:LASER OFF<LF>]
Selects anode on ground
Selects cathode on ground
Reads the laser diode polarity
[:LDPOL AG<LF>]
[:LDPOL CG<LF>]
Programs the laser diode current limit
Reads the laser diode current limit
[:LIMC:SET <NR3><LF>]
Reads the minimum possible laser diode current limit
[:LIMC:MIN <NR3><LF>]
Reads the maximum possible laser diode current limit
[:LIMC:MAX <NR3><LF>]
Reads the laser diode current limit for
Ilim – DAC = 0000
[:LIMC:MIN_W <NR3><LF>]
Reads the laser diode current limit for
Ilim – DAC = FFFF
[:LIMC:MAX_W <NR3><LF>]
and I
MAX
Commands
" on page 14)
TE LIM
49