Commands; Select A Module Slot; Calibrating A Photo Diode (Calpd) - THORLABS ITC8 Series Operation Manual

_________________________________________________________________________________

3.2 Commands

3.2.1 Select a module slot

":SLOT <NR1>"
":SLOT?"

3.2.2 Calibrating a photo diode (CALPD)

Programming:
":CALPD:SET <NR3>"
Reading:
":CALPD:SET?"
":CALPD:MIN?"
":CALPD:MAX?"
_____________________________________________________________________________________________________
© 2010 Thorlabs
Selects a slot for further programming
<Nr1>=1...8 (PRO8000), 1...2 (PRO800)
Queries the selected slot
[:SLOT <NR1><LF>]
Programs the sensitivity calibration factor (η) of the
monitor diode (A/W)
Reads the sensitivity (η) of the monitor diode
[:CALPD:SET <NR3><LF>]
Reads the minimum allowed sensitivity (η) of this
module
[:CALPD:MIN <NR3><LF>]
Reads the maximum allowed sensitivity (η) of this
module
[:CALPD:MIN <NR3><LF>]
Commands 43