Selecting A Module; Setting The Main Parameter - THORLABS ITC8 Series Operation Manual

28 Functions in the main menu
_________________________________________________________________________________

2.1.2 Selecting a module

To select a module move the cursor with the softkeys
channel number.
CH2
Pressing will lead to the channel menu
(Refer to chapter 2.2, "Functions in the channel menu" starting on page 29)

2.1.3 Setting the main parameter

To set the main parameter move the cursor to the desired channel number (here:
CH1):
Press the softkey (TUNE)
Adjust the main parameter, here the laser diode current I
______________________________________________________________________________________________________
CH1 122.3mA +30.0°C
CH2
CH3
to turn the cursor to the right:
CH1 122.3mA +30.0°C
CH2
CH3
TUNE: I
TUNE
T
LD S
, with the tuning knob.
LD
and to the desired
© 2010 Thorlabs