Switching The I-Share On And Off (Integ); Reading The Tec Current (Ite) - THORLABS ITC8 Series Operation Manual

48 Commands
_________________________________________________________________________________
":IMD:STOP?"
":IMD:MEAS?"

3.2.7 Switching the I-share on and off (INTEG)

Programming:
":INTEG ON"
":INTEG OFF"
Reading:
":INTEG?"

3.2.8 Reading the TEC current (ITE)

Programming
":ITE:MEAS <NR1>"
Reading:
":ITE:ACT?"
":ITE:MIN_R?"
":ITE:MAX_R?"
":ITE:MEAS?"
______________________________________________________________________________________________________
Reads the monitor diode stop current for "ELCH"
[:IMD:STOP <NR3><LF>]
Reads the position of the monitor diode current as
measurement value in the "ELCH" output string (1....8,
0 if not selected)
[:IMD:MEAS <NR1><LF>]
Switches the I-share on
Switches the I-share off
Reads status of the I-share
[:INTEG ON<LF>]
[:INTEG OFF<LF>]
Programs the TEC current as measurement value on
position <NR1> in the output string for "ELCH" (<NR1>
= 1....8)
Reads the actual TEC (or heater) current
[:ITE:ACT <NR3><LF>]
Reads the minimum TEC current for
Ite –ADC = 0000
[:ITE:MIN_R <NR3><LF>]
Reads the maximum TEC current for
Ite –ADC = FFFF
[:ITE:MAX_R <NR3><LF>]
Reads the position of the TEC current as measurement
value in the "ELCH" output string (1....8, 0 if not se-
lected)
[:ITE:MEAS <NR1><LF>]
© 2010 Thorlabs