Changing Parameters - THORLABS ITC8 Series Operation Manual

Combined module for pro8000, pro8000-4, pro800 systems
Table of Contents

Advertisement

_________________________________________________________________________________
The operating mode field and the status field shows the actual status:
CC on/off
CP on/off
AD on/off
TH on/off
Open
ILK
OVL
LIM
WIN
Vcc
fail
OTP
SENS

2.2.2 Changing parameters

To set or change a numerical set parameter in the channel menu select the
respective line with the cursor:
Example: I
is to change:
LD
_____________________________________________________________________________________________________
© 2010
Thorlabs
constant current mode
constant power mode
sensor is AD 590
sensor is thermistor
TEC output switched on but too high-impedance
interlock open
laser diode output open
laser on but current has reached the limit value
TEC temperature out of activated temperature window
Internal Power failure, contact
over temperature
wrong or no sensor connected
CH1
I
CC off P
TH off T
Functions in the channel menu
Thorlabs
= 44.000mA
LD
=0.70000mW
LD
= + 22.60°C
A
CHANGE
31

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the ITC8 Series and is the answer not in the manual?

Table of Contents