5�27�- Temperature Alarm - Circutor Computer SMART III 6 Instruction Manual

5�27�- TEMPERATURE ALARM
In this point the thresholds above which the temperature alarm (
Note: The alarm must be enabled (
Press the
digits to be modified.
The parameters to be configured are:
 The
and if alarm
and activates alarm
 The
if alarm
activates alarm
If the device falls back under the
to the normal operating status.
In the No Connection status, the device does not connect the stages, but also does not disconnect
them if the operation requires it.
In the Disconnection status, it disconnects all the stages and does not allow them to connect.
The key increases the digit value.
The
The
Press
Lo
Value and
102
key to enter edit mode. It is identified by the
Lo
value: when the device exceeds this value for 30 minutes, alarm
E11
is enabled
E11
.
HI
value: if the device exceeds this value for 30 seconds, alarm
E12
is enabled, the Computer SMART III device enters the Disconnection status and
E12
.
key reduces the digit value.
key skips to the previous digit and the
to validate the data; the
HI
Value:
Maximum value: 80ºC.
Minimum value: 0ºC
"5.21.- ENABLING ALARMS"
,
the Computer SMART III device enters the No Connection status
Lo
value during 10 minutes, it deactivates the alarms and returns
key skips to the next digit.
symbol disappears from the display.
Computer SMART III
E10
) is activated can be configured.
).
symbol and the flashing of the
E09
Instruction Manual
E09
is triggered,
is triggered, and