5�24�- Cos Φ High Alarm - Circutor Computer SMART III 6 Instruction Manual

If the value entered is lower than the minimum value or higher than the maximum value, the backlight
of the display flashes and the value entered is replaced with the minimum or maximum value, or with
the last value validated.
Press the
If no keys are pressed for 5 minutes, the device switches to the simulation screen,
.
SCREEN"
5�24�- COS
The high limit of the cos φ alarm is set at this point. This is activated whenever the value of cos φ is
above the specified value and the current is higher than the programmed value.
Note: The alarm must be enabled (
Press the
digits to be modified.
In order to avoid possible false activations of said alarms, they have a predefined delay of 15 seconds.
The current value�
The cos
The key increases the digit value or shows the next option.
The key reduces the digit value or shows the next option.
The
Press
Current:
98
key to access the next programming step.
HIGH ALARM
φ
key to enter edit mode. It is identified by the
value, it is capacitive
φ
key skips to the previous digit and the
to validate the data; the
Maximum value: 9999 A
Minimum value: 0 A
"5.21.- ENABLING ALARMS"
C
.
key skips to the next digit.
symbol disappears from the display.
Computer SMART III
"5.30.- SIMULATION
).
symbol and the flashing of the
Instruction Manual