5�27�- Temperature Alarm - Circutor Computer SMART III FAST 6 Instruction Manual

5�27�- TEMPERATURE ALARM
In this point the thresholds above which the temperature alarm (
Note: The alarm must be enabled (
Press the
digits to be modified.
The parameters to be configured are:
 The
and if alarm
and activates alarm
 The
alarm
activates alarm
If the unit falls back under the
normal operating status.
In the No Connection status, the unit does not connect the stages, but also does not disconnect them
if the operation requires it.
In the Disconnection status, it disconnects all the stages and does not allow them to connect.
The key increases the digit value.
The
The
Press
Lo
Value and
100
key to enter editing mode. It is identified by the
Lo
value : when the unit exceeds this value for 30 minutes, alarm
E11
is enabled
E11
.
HI
value: if the unit exceeds this value for 30 seconds, alarm
E12
is enabled, the Computer SMART III FAST unit enters Disconnection status and
E12
.
Lo
key decreases the digit value.
key skips to the previous digit and the
to validate the data; the
HI
Value:
Maximum value: 80ºC.
Minimum value: 0ºC
"5.21.- ENABLING ALARMS"
,
the Computer SMART III FAST unit enters No Connection status
value for 10 minutes, it deactivates the alarms and returns to the
key skips to the next digit.
symbol disappears from the display.
Computer SMART III FAST
E10
) is activated can be configured.
).
symbol and the blinking of the
E09
E09
is triggered, and if
Instruction Manual
is triggered,