Xilinx Artix-7 FPGA AC701 Getting Started Manual page 30

Advanced Bring-up with Base Targeted Reference Design
After installing the driver, the control and monitoring user interface appears as shown in
Figure
generator, or checker) and packet length. The system monitor tab shows system power and
temperature. The GUI also provides an LED indicator for DDR3 memory calibration.
X-Ref Target - Figure 24
Figure 24: Artix-7 FPGA Base TRD Control and Monitoring Interface
Using the Application GUI
The transmission and reception of data is configured through the application GUI. The
GUI displays collected statistics and other status information.
At startup, the GUI displays a launching page that detects the PCIe device for this design
(Vendor ID = 0x10EE and Device ID = 0x7042). When the appropriate device is detected,
driver installation is allowed to proceed. An additional option is available which allows
the enabling of a data integrity check. Upon successful installation of the drivers, the
control and monitoring interface appears.
GUI Control Function
These parameters are controlled with the GUI:
•
30
Send Feedback
24. The control view shows control parameters such as test mode (loopback,
Packet size for traffic generation.
www.xilinx.com
UG967_24_111312
AC701 Getting Started Guide
UG967 (v4.0.1) March 05, 2014