Xilinx Artix-7 FPGA AC701 Getting Started Manual page 21

•
Hardware Demonstration Setup
This section details the hardware setup and use of the provided control and monitoring
application and GUI to assist in getting started quickly with the hardware. Step-by-step
explanations are provided on hardware bring-up, software bring-up, and the use of the
application GUI.
Board Setup
This section details how to set up the AC701 evaluation board as required for
demonstrating the TRD.
Setting the AC701 Jumpers And Switches
1.
Table 3: AC701 Board Required Jumper Settings
Table 4: AC701 Board Required Switch Settings
AC701 Getting Started Guide
UG967 (v4.0.1) March 05, 2014
Advanced Bring-up with Base Targeted Reference Design
A PC with PCIe v2.1 compliant slot. For a complete list of recommended machines,
and all known issues, see
Answer Record (AR 53372).
Note:
The PC could also have Fedora 16 Linux OS installed.
Turn off the power to the AC701 board and verify the switch and jumper settings are as
shown in Table 3, Table 4, and
Jumper
J12 PCIe endpoint configuration width; 4-lane design
Switch
SW15 Board power slide-switch
SW2 User GPIO DIP switch
4
3
2
1
SW1 Positions 1, 2, and 3 set configuration mode
3 001 – Master SPI
101 – JTAG
2
1
www.xilinx.com
Artix-7 FPGA Base Targeted Reference Design Master
Figure 15.
Function
Function/Type
Setting
3-4
Setting
off
off
off
off
off
on
off
off
21
Send Feedback