Xilinx Artix-7 FPGA AC701 Getting Started Manual page 26

Advanced Bring-up with Base Targeted Reference Design
The PC should boot from the DVD-ROM drive. The images in
monitor during startup.
X-Ref Target - Figure 19
3.
26
Send Feedback
First Screen
Figure 19: Fedora 16 LiveDVD Boot Sequence
After Fedora boots, open a terminal window (click Activities > Application, scroll
down, and click the Terminal icon).
To determine if the PCIe integrated block is detected, at the terminal command
prompt, type:
$ lspci
The lspci command displays the PCI and PCI Express buses of the PC. On the bus
corresponding to the PCIe connector holding the AC701 board, look for the message:
Memory controller: Xilinx Corporation Device 7042
This message confirms that the design programmed into the AC701 board is detected
by the BIOS and the Fedora 16 OS. The bus number varies depending on the PC
motherboard and slot used.
www.xilinx.com
Figure 19
Last Boot Screen
AC701 Getting Started Guide
UG967 (v4.0.1) March 05, 2014
are seen on the
Boot Complete
UG967_19_111212