Xilinx Artix-7 FPGA AC701 Getting Started Manual page 10

Basic Hardware Bring-up with Built-In Self-Test
For a description of all features on the AC701 Board, see AC701 Evaluation Board for the
Artix-7 FPGA User Guide (UG952)
Test Setup Requirements
Note:
The prerequisites for testing the design in hardware are:
•
•
•
•
•
•
•
Hardware Test Board Setup
This section details the hardware setup and use of the terminal program for running the
BIST application. It details step-by-step instructions for board bring-up. For more
information on installing the tools and drivers, see the
AC701 Evaluation Board Setup
1.
X-Ref Target - Figure 3
10
Send Feedback
This example design uses a Windows 7 PC flow and TeraTerm Pro.
AC701 evaluation board with XC7A200T FPGA
Type-A to mini-B USB cable (for UART)
Type-A to micro-B USB cable (for JTAG)
AC Power Adapter (12 VDC)
TeraTerm Pro or other terminal program
USB-UART drivers from Silicon Labs
Vivado Design Suite installed on host PC
Set DIP switch SW1 as shown in
OFF Position = 0
Figure 3: SW1 Switch Settings for JTAG Programming Mode
www.xilinx.com
[Ref 1].
Boards and Kits Install
Figure 3 (ON, OFF, ON = 101).
ON Position = 1
M2 M1 M0
1 2 3
SW1
UG967_03_102813
Guide.
AC701 Getting Started Guide
UG967 (v4.0.1) March 05, 2014