Xilinx Artix-7 FPGA AC701 Getting Started Manual page 16

AMS Bring-up with the AMS101 Evaluation Card
3.
X-Ref Target - Figure 11
16
Send Feedback
c. Open Hardware Session.
d. Open a new hardware target and run through the wizard.
e. Click the open_cable command and select OK.
f. Open xadc_eval_design.bit from the AC701 board AMS design folder:
xadc_eval_design_ac701_v1_0 > ready_to_test > xadc_eval_design.bit
Open the AMS Evaluator tool.
a. Running the setup program loads the AMS101 Evaluator GUI with the Xilinx logo
on your desktop. Figure 11
click the Connect button. When the button is green, click the Collect Data button
in the center to quickly evaluate the analog signals in the time and frequency
domain, display linearity, verify the XADC Registers settings, and measure the
internal temperature sensor and supply voltages.
b. Collect Data button in the center to quickly evaluate the analog signals in the time
and frequency domain, display linearity, verify the XADC register settings, and
measure the internal temperature sensor and supply voltages.
c. Figure 12 shows the XADC results in the frequency domain.
d. The AMS101 evaluation card provides a dual 16-bit DAC for use as an analog test
source. External analog signals can also be applied to the card. For a more
extensive explanation of the AMS101 evaluation card and the various functions in
the AMS Evaluator tool, see AMS101 Evaluation Card User Guide (UG886)
Figure 11: AMS Evaluator Tool
www.xilinx.com
shows the AMS101 Evaluator after opening. From here,
[Ref 16].
UG967_11_112712
AC701 Getting Started Guide
UG967 (v4.0.1) March 05, 2014