Advertisement
Step 31: Attach TNR3 Slide Exit to Exit Elbow Assembly
A: Insert flange of Exit Elbow Assembly (slide elbow) into the slots on TNR3 Short Exit. (fig. 31.1)
B: Rotate Slide Exit and use Quadrex Driver as a guide pin so the holes are aligned and attach with 5 (PB1) 1/4
x 3/4" Pan Bolts (with lock nuts) starting with the bottom middle hole and working up each side. (fig. 31.2 and
31.3)
C: At this point make sure all the slide bolts are tight. Use a 7/16" open end wrench to hold nut and then
tighten bolt with Quadrex Driver on Clamp Rings.
Fig. 31.1
TNR3
Short Exit
Fig. 31.2
Exit Elbow
Assembly
Slot of TNR3
Short Exit
Lock
Nut
PB1
Hardware
5 x
1/4 x 3/4" Pan Bolt
PB1
(1/4" lock nut)
76
Fig. 31.3
Lock
Nut
PB1
Bottom of Slide Views
Start with
this bolt
PB1
Other Parts
1 x TNR3 Short Exit
Advertisement
