Advertisement
Step 6: Join Swing and Slide Wall Assemblies
Part 2
C: From inside the assembly, tight to both (040) Slide End Wall and (050) SW Wall Panel, halfway up the
assembly, 5/8" below the panel, loosely attach 1 (061) Side Joist to (041) Narrow Back Panel and (052) Back
Wall Panel with 3 (WB10) 5/16 x 2-5/8" Wafer Bolts (with flat washer and t-nut). Bolts are installed from inside
the assembly. Make sure (061) Side Joist is level then attach with 2 (S3) #8 x 2-1/2" Wood Screws and tighten
bolts. (fig. 6.3, 6.4 and 6.5)
D: Repeat Step C to attach 1 (061) Side Joist to (042) Narrow Front Panel and (051) Front Wall Panel. (fig. 6.3
and 6.4)
Fig. 6.3
041
Fig. 6.4
Inside View
040
Tight
Wood Parts
2 x
Side Joist 2 x 2 x 63"
061
S3
4 x
S3
6 x
WB10
052
5/16"
T-Nut
5/16" Flat
Washer
WB10
Hardware
#8 x 2-1/2" Wood Screw
5/16 x 2-5/8" Wafer Bolt
(5/16" flat washer, 5/16" t-nut)
27
050
061
S3
Fig. 6.5
Panel
5/8"
061
Tight
Advertisement
