Advertisement
Step 9: Attach SW Ground and Diagonal
A: Loosely attach (090) SW Ground to (091) Diagonal with 1 (WB9) 5/16 x 2-1/8" Wafer Bolt (with flat washer
and t-nut) then place (091) Diagonal tight and flush to the front of (050) SW Wall Panel. (090) SW Ground to be
flush to the bottom of (050) SW Wall Panel. (fig. 9.1 and 9.2)
B: Pre-drill pilot hole with a 3/16" drill bit then attach (091) Diagonal to (050) SW Wall Panel with 1 (WL5) 1/4 x
2-1/2" Wafer Lag (with flat washer), checking that it remains flush to outside edge. (fig. 9.1 and 9.2)
C: Making sure bottom of (090) SW Ground is flush to bottom of (050) SW Wall Panel pre-drill with a 1/8" drill bit
then attach with 2 (S11) #8 x 2" Wood Screws and 1 (S4) #8 x 3" Wood Screw then tighten the bolt. (fig. 9.1 and
9.2)
Fig. 9.1
Wood Parts
1 x
SW Ground 5/4 x 4 x 14-1/4"
090
1 x
Diagonal 1-1/4 x 3 x 22"
091
050
091
5/16"
T-Nut
090
Hardware
WB9
1 x
5/16 x 2-1/8" Wafer Bolt (5/16" flat washer, 5/16" t-nut)
1 x
1/4 x 2-1/2" Wafer Lag (5/16" flat washer)
WL5
1 x
#8 x 3" Wood Screw
S4
2 x
#8 x 2" Wood Screw
S11
5/16" Flat
Washer
WL5
WB9
5/16" Flat
Washer
33
Fig. 9.2
050
Flush
Flush
S4
S11
Advertisement
